|
Tackle,
Rigs and Baits
Tackle
(a)
General
Always use balanced
tackle that is in good condition and suitable for the species and fishery
situation. If in doubt, seek advice.
Be aware that
'line class' records can give rise to fishing with tackle that is far
too light for the intended quarry. This is actively discouraged.
Do
not fish in areas where lost fish are a virtual certainty (i.e. excessively
snaggy swims).
(b)
Pole Fishing
When
fishing canals do not place your pole across the towpath, restricting
the access rights of other users. The same applies to park lakes and other
busy places with public access.
Ensure that spare poles and pole sections are positioned parallel to the
bank, preferably on a pole rack, to allow unobstructed passage for other
bankside users.
When landing fish ensure that your pole can be unshipped without causing
similar obstruction.
Always ensure that you remove your pole in good time to allow boats to
pass.
Never allow your pole to encroach onto other people's gardens, fences
and paths etc without permission.
Do not leave your pole unattended with a baited hook-left in the water;
it endangers fish, is particularly vulnerable to tackle loss, and is illegal
(Environment Agency Bylaw), and baited hooks left out of the water can
be picked up by birds and animals.
Pole fishing leaves you particularly vulnerable to overhead power cables-LOOK
OUT-LOOK UP!
Take
the weight of long poles across your knees to reduce the risk of back
strain.
(c)
Rod numbers/night fishing
Never
leave baited rods unattended or unsupervised. Agency byelaws require that
while fishing, all rods should be under sufficient control of the angler.
Current legislation in England and Wales permits an angler to fish for
coarse fish with a maximum of four rods at any one time. Each rod licence
entitles the angler to use two rods, with two separate licences required
if three, or four rods are to be used. Note that although the four rod
limit is a National bylaw in England and Wales, fishery owners or managers
retain the right to set a lower limit, if they deem it more suitable.
Whilst on waters
with low fish densities multiple rods can be used with no detrimental
effects, where fish stocks are high multiple rod usage may not be appropriate
and a number of points should be taken into consideration when deciding
on the number to use;
H ow many rods
are actually needed to catch? A single rod approach would be more suitable
for certain types of fishing. When fishing for less pressurized fish,
or alternatively, fish that are wary of disturbance, a single rod approach
can be more effective.
Are you able to fully control multiple rods, and use them sensibly, without
impeding the fishing of others in any way? The swim must also be able
to accommodate them too.
Will you be in control of all rods in use, with effective visual and/or
audible bite indication (preferably both) on each? On no account should
baited rods be left unattended or unsupervised (Environment Agency Byelaw)
It is recommended that some spacing is left between rods through using
either two pods of two rods each, or single bank sticks, to help avoid
tangles. Note however that the rods must be placed
such that the distance between the butts of the end rods does not exceed
three metres (Environment Agency Byelaw)
Never exceed the number of rods permitted on the fishery, or the number
dictated by the applicable Environment Agency bylaw. Ignorance of the
rules, or the law, is no defence.
Multiple rod
usage can certainly enhance angling productivity, but use only when suitable!
We would also add that long stay anglers in particular often fish whilst
asleep, which is completely acceptable providing bite alarms are properly
used to ensure a bite wakes the angler instantly. Do check buzzers will
wake you even when asleep, extension boxes will provide good warning without
disturbing other anglers. Also consider speed of access to your rods by
putting the bivvy as close as possible, and leaving the door and sleeping
bag unzipped whenever practical.
Rigs
(a)
General
Your
first priority is the safety and well-being of the fish.
Tether-rigs
must not be used. If the line breaks, the tackle must be free to slide
off the line - a towed lead, feeder or float could snag and trap the fish.
(For examples
of these dangerous rigs, and some acceptable alternatives, see Appendices
C, D, E, F, G, H, & I.)
Remember that
if shock-leaders are used, the leader-knot must always be able to slide
through the rig. Also consider the use of barbless or reduced barb hooks
as an additional precaution.
While the deliberate
foul-hooking of fish is illegal, it is inevitable that this occasionally
happens accidentally. Some regional Agency byelaws require that accidentally
foul-hooked fish are returned immediately to the water. Other byelaws
limit the number and/or size of hooks that may be used in conjunction
with a single rod or attached to a lure, in order to reduce the likelihood
of foul-hooking fish. Avoid rigs that are likely to result in foulhooking.
Similarly, rigs that are likely to result in deep-hooking of fish should
be avoided.
Great consideration
should be given before using double-hook rigs, where two separately baited
hooks are employed on the same rod. Extreme caution should be taken, and
they should not be used in heavy weed. They may also be banned in some
regions by the local byelaws. To avoid the dangers of leaving a fish tethered
to a snag in the event of a break in the main line, both hook links must
be free to slide off the line.
Please use
barbless or reduced barb hooks wherever possible; the widespread use of
these should be actively encouraged, especially barbless in the smaller
sizes, 14 downwards. Note however some anglers believe large barbless
hooks can be harmful, particularly for perch.
Bent hooks should
not be used (The term "bent" hooks refers to certain long shank
carp hooks bent at 30° in the middle)
The use of most
sizes of lead weights is illegal and non-toxic weights are widely available.
Lead weights of 0.06grams (No.8 shot) or less or of more than 28.35 grams
(1oz) may be used. While it is legal to use lead "dust" shot
in size 8 and smaller, they are toxic if ingested by birds, and should
be used with care; always use in spill-proof containers and dispose of
used lead safely at home.
Lead core leaders
as used for carp fishing can easily tangle on underwater snags due to
their tendency to wrap
around snags, etc. and tether a fish, should the main-line break. There
is a substantial body of opinion against
the use of lead-core leaders. If they are to be used we strongly recommend
that extreme caution be exercised
and the following points be adopted;
Maximum
length of lead core leader should be 3Õ, holding down longer lengths
of line than this can easily be achieved by using flying back-leads
Leads MUST be able to slide over the leader-knot so a lost fish is not
also towing the lead as well as the leader; splicing the two lines together
in accordance with the instructions given by the manufacturers of lead
core is usually sufficient to achieve this but do CHECK that the lead
can detach itself from the leader
12lb minimum main line to be used
As an added precaution the use of safety leads (inline) or safety-clips
(pendant) which release the lead, is recommended; check that the safety
clip does release the lead properly
Lead core should not be used with helicopter-rigs as there are too many
opportunities for the hook link to jam on the lead core, leaving a lost
fish towing a lead
Consider using a barbless hook as an added precaution to release a tethered
fish
Lead core should never be used on weedy or snag filled waters (which would
in any case largely work against the purpose of lead core)
Rigs
(b)
For Predators
On most waters
when bait fish are used, pike are usually the target species. Wire traces
must always be used for both pike and zander. Otherwise, they can bite
through the trace, leaving hooks etc. in the fish, with potentially fatal
results.
For lure-fishing
too, regardless of target species, wire traces should be used.
For additional
points on pike and zander tackle, rigs and baits, see Appendices J, K,
& L.
It is recognised
that the use of wire traces may be an impediment to eel and perch angling.
As a first step, please consider the use of wire covered with soft silicone
tubing. Failing this, employ braids with a high degree of abrasion resistance
as a hook link. For eels, perch and catfish, use a single hook only (though
not stainless steel, which does not easily corrode); do not use double
or treble hooks. If a pike or zander does still take this, and bites through
the hook link, a single hook is very unlikely to cause any damage.
If
pike or zander are taking baits presented on hook-links for eels, catfish,
perch or chub, carefully consider changing bait or venue, or in the case
of eels and perch, accepting a lower catch rate through reverting to wire
traces.
Baits
Always use free bait
offerings and groundbait in sensible quantities to ensure that uneaten
food does not accumulate in fisheries, especially small, shallow bodies
of still water. This will protect the quality of the aquatic environment
and safeguard other anglers' sport.
Observe any
fishery rules on bait restrictions.
For bait-fish,
also see section five 'Fish Movements & Disease'.
Thoroughly
soak and cook all nuts, seeds and pulses. (See Appendix B)
Return
to Contents
|